AdrianL
Joined: | Friday May 2nd, 2008 |
Location: | West Sussex, UK |
Posts: | 64 |
Status: |
Offline
|
back to top
|
I have removed UCM02 and scanning now reveals just UCM01 and UCM03. I have downloaded the configuration to Comfort and it reports Communication failure on UCM02 in the Event Log. I presume from your last reply that I have to change the UCM/Z-Wave in use to have ID = 2 to get rid of the communication error. Can I just change the DIP on the UCM board or must I exclude it from the Z-Wave network, change the ID and then include again?
|