View single post by slychiu

Posted: Wednesday Feb 22nd, 2017 06:53 am

Joined:	Saturday Apr 29th, 2006
Location:	Singapore
Posts:	5500
Status:	Offline

You can just change the ID and reset the UCM or Comfort. It should not affect the zwave mapping.
Then do Scan for Modules again so Comfigurator can see that the ID has changed to 2
It may show a blank Zwave mapping (not sure abbout this), but if that is the case do a Read from EEPROM which will load the parameters from the UCM/Zwave

If you have used mapping to Flags and Counters then no other changes are needed
If you have used the zwave actions, check that the name reference to the UCM still works after your change of ID

Close Window