| PM | Quote | Reply | Full Topic |
| Joined: | Saturday Apr 29th, 2006 |
| Location: | Singapore |
| Posts: | 5498 |
| Status: |
Offline
|
Will I see all of my HC2 connected devices in comfort?
You add the Comfort UCM/Zwave like another zwave secondary controller
That will allow you to see all the zwave devices which have been added by the primary (HC2)
What will Fibaro see on Comfort? Will it be able to see the status of my various PIR or door relays?
You may not see the zones directly with Fibaro. But yoiu can add virtual Nodes to UCM/Zwave and map to Flags. Zones On and off can set/clear flags so Fibaro will be updated by the relevant flag when the zone changes state. This assumes you want to use HC2 to see the state of virtual zwave nodes in Comfort. If there are catual zwave devices which are mapped to the zones then Zone on and off responses can send status to the zwave devices
The other option is to rip out comfort and use all Fibaro sensors but Comfort has been super reliable and Fibaro much less so. I would ideally like to continue with comfort as my alarm but allow it to activate some of the fibaro connected devices such as lighting linked to a door bell being pressed or pir triggered. Is that possible?
You can map zwave devices to counters and flags. when counters and flags chyange then the zwave device is also changed accordingly. hence doorbell, PIR etc can set flags to send the status to Zwave
Also zone open and close Responses can send commands to zwave to update the zwave device status
| Close Window |