View single post by caravanboy | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Tuesday May 16th, 2017 02:12 am |
|
||||||||||||
caravanboy
|
Hi, this seems a daft question to ask... I'm nearing the end of my physical installation and I found a TPB01 in the box that I'd forgotten I'd ordered years ago. I've attached a photo. Due to the types of connectors it looked as though it was designed to clip on to the main Comfort board and then clip the existing TEL-IN connector on top? I puzzled over it though and based on tracing the PCB I concluded that would invert the two wires (and I recall having phone line issues when that initially happened at my old house - without a TPB). So, am I just being daft - which way am I supposed to connect this, or has the pre-installed connector in the photo been put on the wrong way around at the factory? It can't be clipped to the main board as-is or the components would hit the metal casing. Swapping the connector around would be problematic as the screw-terminals seem to be biting-down on the trace that is only on the bottom face of the board. Thanks. Attachment: TPB01_Front.jpg (Downloaded 20 times)
|
||||||||||||
|