View single post by timraynor
 Posted: Wednesday Oct 4th, 2017 11:14 pm
 PM  Quote  Reply  Full Topic 
timraynor

 

Joined: Wednesday Oct 4th, 2017
Location:  
Posts: 3
Status: 
Offline

  back to top

Hi,

I've got an old Comfort I system. The main PCB has a chip labelled “Outside 4.169” A006166.  The slave SEP modules have a chip labelled First 4.164.  The SEP PCB is SM0223.

I've noticed that when arming or disarming the S12V connection on the SEP does not switch off, whereas it does on the main CPU.  I suspect this might have always been happening.  Both SEPs exhibit the same the problem, so I don't think it's a faulty PCB.

I found in the forum that there may be a jumper that needs removing (J7).  I removed that, pressed the SEP reset button and tried again, but no luck.  Have I got the right jumper?

I know it's a very old system but as it's functioning perfectly other than this, I'm reluctant to upgrade it.

Any ideas?

Kind regards,

Tim
 

Last edited on Thursday Oct 5th, 2017 01:41 am by timraynor

 Close Window