View single post by rhennessysummit | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Monday Jan 8th, 2018 01:18 am |
|
||||||||||||
rhennessysummit
|
Hi, I had a Comfort II system installed by around end 2011. I don't know the Comfort firmware version. The installer did some maintenance around 2014 so may have upgraded the firmware but I cannot confirm. I want to purchase the Comfort UCM Ethernet Interface V3 (UCM06/ETH03) to allow me to start playing with Comfort features and see there are some firmware requirements. I read UCM Firmware 7.028 and above is required for UCM that comes with UCM/ETH03. I presume this is for the UCM that comes with the ETH03? If so, I'd hope the package I buy would have the correct firmware. Are there minimum firmware requirements for Comfort also to work with UCM/ETH03? Reason I ask is because I don't have any USB interface to Comfort, I was hoping I could use the ETH03 for firmware upgrades and programming going forward. If I need to upgrade Comfort firmware before I can use ETH03 then I will also need to purchase UCM/USB which I'd like to avoid to save cost. Any assistance appreciated. Thanks!
|
||||||||||||
|