View single post by burtonjk
 Posted: Sunday Apr 8th, 2018 01:41 pm
 PM  Quote  Reply  Full Topic 
burtonjk

 

Joined: Tuesday Aug 21st, 2012
Location:  
Posts: 22
Status: 
Offline

  back to top

Good Morning

Faced with a complete lock up in all communications between Comfort and SmartThings, I looked at my Comfort UCM and found the Eth03 wasn't responding to a Ping. I pressed the reset button on eth03 and regained communications.


At this point I noticed that some comfort zones briefly communicated with SmartThings. But not for long, so I went to the UHAI page for a look and noticed that it was now showing the dreaded 0M Free disk space. I tried to download logs again, but still getting a 0KB logs.tar.gz file.


I flushed the logs and reclaimed 4M of disk space.


There was still nothing happening on SmartThings so I reset the Comfort Bridge Thing while monitoring the Comfort Bus. Nothing appeared on the Comfort Bus, but the Free disk space quickly reduced to 1.3M and is still going down.


My simplistic analysis tells me that SmarThings is communicating with the Pi, but the Pi is failing to communicate with Comfort.


I have studied the post on Free space problem and can confirm that I have a Pi certified 2A psu, but while I have been typing this post, I am now down to 0M again.


So now I appear to have 2 urgent areas to tackle:


1) Re-install the image. From the post, I couldn't see if there was a method to re-install the image whilst retaining the setup. Is this possible?


2) Find out if I have a hardware problem or a network connectivity problem. For this I really need to get the UHAI logs.


Thanks

Jim

 Close Window