back to top

• Read User Codes only visible in Engineer Advanced mode, not in User or Simplified Engineer or EMS modes - Old bug
  
• Virtual Mode Drag/drop- if a Virtual Input zone is dragged to another zone, the new zone remains virtual but the reference remains at the previous zone number - Old bug
• In User Mode, Control menu with feedback and without actions cannot see feedback - Old bug
• User mode Control Menu press action  key works 1 time only - Old bug
• IRIO "Reset to default" button does a full read from IRIO
• HIO – when show status is checked, Read from HIO causes Unhandled exception 
  
• Copy Counters Action does not cause addressed Counters to be shown as referenced (in blue) - Old bug
• In UCM/GSM4, when copying the text from Comfort for Control Menu, the check for 8 characters maximum for Control Action words is not done. Control Action words are limited to 16 for Alternative Text. Is the SMS any text with more than 8 characters in Control Action words is truncated - Old Bug
• After Scanning for Modules, the latest firmware for HIO, MSM01, TSM01 are shown as "Unknown"
• UCM/Modbus - In  Modbus to Comfort Tab, check "Show Status " caused exception for some files

• "If Virtual Input" condition caused exception
•  TSM01 virtual Input when assigned cannot be unassigned, bug only in EMS, not in ULT
•  KP04A EMS – Prevent changes should be seen in EMS Mode only, not Alarm Mode
  

• Support for the new MSM01 MultiSensor Module is available
  
• Scan for Individual Modules has been removed. Only Scan for all modules is available
• Configuration > Voice Settings > Keypad and Phone Announcement Levels Minimum to Maximum Range on the slider have been changed to allow lower volumes for announcements

Last edited on Saturday Sep 22nd, 2018 11:07 am by slychiu