Comfigurator 3.12.8
Bugs- MSM01 - Default for "Water Leak Sensor Change Report" is wrong.
- MSM01 - Input 4 settings does not Write to EEPROM correctly. "Read from EEPROM" shows Input 4 is unchanged
- When IRIO Digital zone mapped to Virtual Input – the Zone Reference to IRIO is not seen
- In View User Mode, when Control Key has Sensor Feedback and no actions, the Sensor is not seen. It works in other view modes
Bugs Fixed- UCM/Modbus - In Modbus to Comfort Tab, check "Show Status " caused exception for some files
- RIO Digital Input mapped to Virtual Input, the Zone was not shown as Virtual
- Copy Counters Action did not cause addressed Counters to be shown as referenced (in blue)
- In UCM/GSM4, when copying the text from Comfort for Control Menu, the check for 8 characters maximum for Control Action words was not done. Control Action words are limited to 16 for Alternative Text.
- After Scanning for Modules, the latest firmware for HIO, MSM01, TSM01 are shown as "Unknown"
- IRIO "Reset to default" button dID a full read from IRIO
- HIO – when show status is checked, Read from HIO causeD Unhandled exception
New Features & Changes- Sensor changes are recorded in Event log for CM9001-EMS only
- Browse for new template starts at Comfigurator's Config folder
- When Comfigurator writes to KP04A or KP06A and the partition is changed, Comfigurator sends reset o Comfort in order to load the new partition
- HIO added option for sensor NO/NC
- IRIO If Comfigurator is showing “Submodule- None†in either the 1st or 2nd submodule, show the detected sumodules in the correct location 1 and/or 2.
- IRIO Reset to Default should default to the 2 detected submodules if IRIO is connected, instead of to blank. (Previously Reset to Default gives a message that the IRIO installed is different from the currentconfiguration) so Reset to Default was no use when IRIO is connected
Last edited on Saturday Sep 22nd, 2018 11:17 am by slychiu
|