View single post by MCFH
 Posted: Sunday Sep 30th, 2018 10:41 am
 PM  Quote  Reply  Full Topic 
MCFH

 

Joined: Sunday Feb 17th, 2008
Location:  
Posts: 7
Status: 
Offline

  back to top

Thanks that has brought the dimmer up on the UI.

However, I note that dragging the slider to near zero doesn't generate a message on the bus (it is fine at say 255) but below around 10 it seems to stop generating messages. I can prove that completely with the numeric entry!


On the scenes the use case I have is say a room kitchen that has three loads. I offer the use: Cook, Dine and Off and ideally the UI would show which is selected - if you deviate from the scene I think something in CBUS would generate the trigger indicator kill and you can leave none selected. However your UI would need to know that the trigger level 5, say, corresponded to dine.

Thanks
Mark

 Close Window