| PM | Quote | Reply | Full Topic |
| Joined: | |
| Location: | |
| Posts: | |
| Status: |
Offline
|
I just posted a thread about our UCM/ETH03 not working. Meanwhile we had a UCM/ETH02 ) still on firmware 5.xx) sitting around that we used to use with our comfort 1.
The timing of our system is out of whack hence the urgency to get into the Comfort and set up the schedule again properly.
In Comfigurator I am not able to connect to it. Using DS manager I was able to setup it up and assign it an IP in our home network, and setup gateway of the adsl router, and appropriate subnet mask. This way I can try and connect via my laptop on Wi-Fi internally in the home network.
But if I try and read the schedule or system information I get an error that connection cannot be made to UCM. So looks like DS Manager can connect but Comfigurator cannot. I tried changing tcp/udp, port number but nothing has helped.
Any tips would be much appreciated..
Also I understand I can swap the sub-module between UCM/ETH02 AND UCM/ETH03 - the ETH03 module seems damaged but hopefully it's UCM board (on firmware 7.xx) is fine.
Thx
Last edited on Tuesday Jan 22nd, 2019 11:41 am by
| Close Window |