auredor
Joined: | Sunday Feb 19th, 2012 |
Location: | |
Posts: | 20 |
Status: |
Offline
|
back to top
|
This is excatly what I did to try to remove "RS485 Comm Failure" (I've used "Not Assigned"). But still, the message is displayed on the keypad and the central monitoring show "RS485 Comm Failure" as alarm state. At least, it doesn't play any siren but the status is very annoying while you're remotely looking at the alarm system state. This is because, in this case, you only see "Communication Failure" instead of either "Armed", "Disarmed", "Alarm"...So, is it not possible de setup comfort such it doesn't check for communication failure ?
Regarding to which group address it's related, I've still have to do my howework to understand.
Thanks.
|