View single post by OhPinchy | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Sunday Jun 2nd, 2019 10:10 am |
|
||||||||||||
OhPinchy
|
I'm trying to get Zwave setup with my Comfort install as there are some Velux windows I need to monitor using Zwave open/close sensors. Zwave UCM is installed and detected and has an aerial installed. I use Samsung SmartThings as my primary controller of the Zwave network. I clicked Read from EEProm and then it says UCM/Z Wave not in any network (which if I read the guides correctly, that should be how it shows up first time). I then clicked Learn and it just stays at "Waiting for response from Z Wave" indefinitely. I set the Timeout 1 and Timeout 2 in Comfort Server Manager to 05 (is that 5 mins?). If it helps, I also have a mini PC running Jinx lighting control software and a Linux box running OpenHab. I have a Zwave USB stick (can't recall which supplier) so could perhaps try that route if there's an issue with SmartThings.
|
||||||||||||
|