View single post by palmlodge

Posted: Saturday Nov 23rd, 2019 10:42 am

Joined:	Thursday Dec 14th, 2006
Location:	United Kingdom
Posts:	507
Status:	Offline

I've come to install, and now not sure so what to connect. The connections on your diagram won't align to what is on the shock sensor itself.
Do I use resistors both at the Comfort panel AND at the shock sensor?
Can I ignore the tamper? If the intruders are in, PIRs will sort out the alarm, these shocks just need to trap external factors.
Do I take the zone output to the shock sensor to EOL1, then loop a 4k resistor to EOL2, and then the common from EOL2 back to the Comfort panel perhaps?
Thanks!

Attachment: texecom impaq s.png (Downloaded 53 times)

Close Window