View single post by slychiu | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Friday Jan 24th, 2020 10:45 am |
|
||||||||||||
slychiu
|
The UCM/ETH03 should be able to work with Comfort 2The first thing to do after you set up and connect the UCM/ETH03 and find its IP address, is to use Comfigurator and Scan for modules so you can see the modules that are connected correctly, and their firmware versions The default user code is 1234 If that dies not work you can reset the user codes to default by the method shown herehttp://www.comfortforums.com/forum16/2357.html Dont upgrade firmware yet until you get most things working If the keypad gas no voice it could be because the IDs are not set correctly to unique ids starting with 1, then 2,3 etcOr ypu may need to upgrade the Vocabulary by Comfigurator
|
||||||||||||
|