slychiu
Joined: | Saturday Apr 29th, 2006 |
Location: | Singapore |
Posts: | 5500 |
Status: |
Offline
|
back to top
|
Here are the instructions to open door/gate using DM02
Programming the Door/Gate Relays
A door strike or automatic gate can be opened from the Door Station menu. The two menu commands;
“4 to Open Gate, 7 to Open Doorâ€
can be programmed to open a gate or a door using a relay connected to any Comfort output or the relays K1 (Gate) and K2 (Door) on the DM02.- Go to Comfigurator > Events > Miscellaneous Events and look for the events Open Door Response and Open Gate Response in the list.
- Select or create a Response to be assigned to Open Door Response and Open Gate Response as required. If no Response is selected, the corresponding menu to Open Gate and/or Open Door will not be announced. Once a nonzero Response is selected, the corresponding menu item will be announced.
- To control the relays K1 and K2 on a DM02, use Action 200 (Open Door). In Response Wizard select Output > Open Door, then select the Door Station ID, the Door number 1 for K1 (Gate) and 2 for K2 (Door), and the duration in 100 ms units.
- If there is more than 1 Door Station, use the IF Door Station ID action to program the outputs according to the ID of the door station eg
If DoorStationId = 49 Then
Pulse Output01 For 20
Endif
If DoorStationId = 50 Then
Pulse Output02 For 20
Endif
If DoorStationId = 51 Then
Pulse Output03 For 20
End If
The above Response for Open Gate or Open Door Response will pulse Output 1 for DP ID 1, output 2 for DP ID2 and Output 3 for DP ID 3.
Note that the relays are rated at 30VDC 3 A
|