mikeinnc
| Joined: | Wednesday Mar 18th, 2015 |
| Location: | Perth, Australia |
| Posts: | 69 |
| Status: |
Offline
|
back to top
|
I must stress before starting that my problem is VERY occasional. Over the last few years, I have 'lost' the ability to see the ethernet module on my home network a couple of times. Quite randomly! Of course, this means I cannot use Comfigurator to access my Comfort system. It is definitely not a 'level 1' (wiring) problem! For some unknown and unexplained reason, my ETH03 module just appears to hang and so can't be accessed. No IP address; can't be 'pinged' etc. I can fix it - relatively easily - by switching the power off to the panel; removing the cover and disconnecting the battery.  When I reapply power, everything is fine again, and it just works - exactly as expected. So, my question is - is there any programmable method using engineer mode from a phone or the keypad (both of which continue to work, of course) by which I can 'reset' the ethernet module. This would be far easier and much more convenient than the power-off; panel access etc method. BTW, this doesn't seem to be a firmware function, either, since it has occurred with a few different firmware variants installed. Many thanks for any comments!
|