View single post by palmlodge
 Posted: Friday Jul 10th, 2020 12:24 pm
 PM  Quote  Reply  Full Topic 
palmlodge

 

Joined: Thursday Dec 14th, 2006
Location: United Kingdom
Posts: 507
Status: 
Offline

  back to top

I'm switching a device, and I need to re-learn some IR commands and replace the old codes.
Whenever I attempt this, I start getting communication errors within 30 seconds or so and Comfort needs a power cycle.

I have multiple UCMs, all work fine, and I can connect to any of them with Comfigurator OK. If I attempt to use the IR learn feature, immediately I get 'no response from UCM' and within 30 seconds the keypad is complaining about a communications failure. I have to power cycle Comfort to clear.
Any ideas?

Attachment: ir failure.png (Downloaded 16 times)

 Close Window