freak69
Joined: | Sunday Aug 9th, 2009 |
Location: | United Kingdom |
Posts: | 28 |
Status: |
Offline
|
back to top
|
Hi,I have recently upgraded my cbus ucm to V2.I have a garage door with a magnetic sensor wired into an input. it registers open or closed depending on the state. I also have an output wired into the garage door button, so comfort can issue a momentary press and open or close the door.What I would like to do is to have a cbus button that i can use to open/close the garage door and its current status is always reflected in the cbus switch (on or off).I have lighting group 21 assigned to the garage door in cbus, and I think I need to configure this as an output toggle in configurator, then configure the physical input to map back to group 21. I don't think I need a response in this case as the UCM handles the momentary press?What do I configure the cbus switch as? If I assign an on/off or bell press to it, the act of pressing the button changes the cbus group and interferes with the back status. Help is appreciated.
Thanks!
|