| PM | Quote | Reply | Full Topic |
| Joined: | Monday Jun 2nd, 2008 |
| Location: | Fareham, United Kingdom |
| Posts: | 20 |
| Status: |
Offline
|
I have also just done the following
I have set up another response to toggle OP11 on and off and assigned Zone 2 which is connected to the PIR. There is an LED connected to OP11.
If I toggle the PIR so the LED turns on and then start toggling mag sensor on Z1 which lights up OP1 and OP9, as soon as it fails, it also switches off the LED on the OP11
As soon as I re-toggle the PIR it switches on again.
This is all rather dodgy! Please help!
Thanks
Adam.
| Close Window |