View single post by ident

Posted: Tuesday Apr 19th, 2011 09:11 am

Joined:	Wednesday Aug 9th, 2006
Location:	Singapore
Posts:	3493
Status:	Offline

Reading the values on the Comfort group addresses from KNX is not supported at the moment, although it is being considered for the future

Comfort always reports the zones and events as they occur so your Homeserver should kepp track of these
If your Homeserver is reset or joins the network later you can reset the UCM/KNX to get UCM/KNX to send its initial values
Otherwise you can program a KNX button to map to a Response which does a system Reset of Comfort

Close Window