Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > Remote Controls > ProntoScript for Comfort Mk 1 |
Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > Remote Controls > ProntoScript for Comfort Mk 1 |
| Moderated by: admin | Topic closed | |
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
admin Administrator 
|
The Pronto models 9300, 9400, 9600, 9800 are able to communicate two way with Comfort to send commands and get status using Prontoscript A sample pronto 9400 .xcf file has been created which has these features (THIS HAS NOW BEEN REPLACED BY MK 2 SEE http://www.comfortforums.com/forum50/1490.html )
Equipment Required
http://www.cytech-technology.com/temp/software/Comfort20090508.xcf Users are free to test and modify it in any way at their own responsibility. Feedback is welcome We may be building on this program to expand its capabilities Screenshots are shown below This screen shows the current security mode and buttons to arm and disarm Comfort Low Battery, AC Fail, Communications failure, Phone Trouble icons will be shown as the events occur Attachment: Pronto9400.jpg (Downloaded 46 times) Last edited on Thursday May 28th, 2009 02:10 pm by |
|||||||||
|
admin Administrator
|
Login with a user code in required when arming or disarming Comfort Attachment: login.jpg (Downloaded 47 times) |
|||||||||
|
admin Administrator
|
Configuration page for Cbus addresses (UCM/CBUS is needed for C-Bus interface) The group address and switch type ie dimming or On/Off can bve specified The UCM ID can be scanned or manually entered The image of the button can be loaded or changed The Cbus switch can be on/off (press and release) or Dim/brighten (press and hold) just like a real C-Bus switch Attachment: Control_cbus.jpg (Downloaded 47 times) Last edited on Monday May 11th, 2009 05:34 am by admin |
|||||||||
|
admin Administrator
|
Configuration page for X10 Attachment: control_x10.jpg (Downloaded 47 times) |
|||||||||
|
admin Administrator
|
Typical control page with buttons which can be for X10, Outputs, C-Bus,, counters The image and names can be changed as required Attachment: control.jpg (Downloaded 47 times) Last edited on Monday May 11th, 2009 05:36 am by admin |
|||||||||
|
admin Administrator
|
Display of Zone status. The zone names can be changed as required Attachment: Zones.jpg (Downloaded 47 times) |
|||||||||
|
admin Administrator
|
Event Log can be read from Comfort and displayed like in Comfigurator Attachment: eventlog.jpg (Downloaded 47 times) |
|||||||||
|
admin Administrator
|
Specify an IP Address and port for the UCM/Ethernet which is in the same network as the Pronto Attachment: IPaddress.jpg (Downloaded 47 times) |
|||||||||
|
admin Administrator
|
There is a problem with the approach with Prontoscript that we have used. The variables are created in Pronto, not in ProntoEdit, and when you switch off the Pronto, there is no non-volatile memory for variables so the setup is lost We will have a new way of configuration using Pronto Edit next week which does not lose the variables when Pronto is switched off This will include KNX/EIB control and many other features |
|||||||||