Comfort  Automation/ Security System Forums Home
Home Search search Menu menu Not logged in - Login | Register

siren output
 Moderated by: slychiu
 New Topic   Reply   Printer Friendly 
 Rate Topic 
AuthorPost
 Posted: Thursday Jul 22nd, 2010 01:45 pm
   PM  Quote  Reply 
1st Post
engmoabel
Member


Joined: Sunday Nov 9th, 2008
Location: Cairo, Egypt
Posts: 39
Status: 
Offline

  back to top

I am using Comfort Ult, Pc900 firmware version 5.183.
I am connecting Comfort PCb, KP03, DP03 , pir and UCM05.
when i make test on siren i didn't work and i measure the volt on the terminal it 3.7 v and when there is no alarm in idle state it measure the same value,
 i connect a siren 12v as follow + to srn+ and - to srn- .
So please advise me with your comment

Last edited on Thursday Jul 22nd, 2010 01:46 pm by engmoabel



 Posted: Thursday Jul 22nd, 2010 02:03 pm
   PM  Quote  Reply 
2nd Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5507
Status: 
Offline

  back to top

Are you measuring the voltage between SRN+ and SRN- ? and not between SRN - to common

If the SRN- is shorted to SRN+ it may damage the siren driver
Try disconnecting the siren wiring from SRN- and SRN+ for a few minutes and try again

If it still does not work send an email to support@cytech.biz



 Posted: Friday Jul 23rd, 2010 05:21 am
   PM  Quote  Reply 
3rd Post
engmoabel
Member


Joined: Sunday Nov 9th, 2008
Location: Cairo, Egypt
Posts: 39
Status: 
Offline

  back to top

i am already measured the vlot between srn+ and srn- not between srn- and com
when i disconnected the siren driver it measured the same number 3.7 V
note:
when i measured the volt after i reset the system the volt value go up and down between 0 and 12v and after short time it gives the same value 3.7V



 Posted: Friday Jul 23rd, 2010 08:50 am
   PM  Quote  Reply 
4th Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5507
Status: 
Offline

  back to top

This should be a programming problem. Each Alarmn Type as a setting for Siren Type, and each Siren Type has a setting for whether the Bell output is activated or not

Send the cclx file to support@cytech.biz so we can check your program



 Current time is 05:59 am
Top




UltraBB 1.172 Copyright © 2007-2014 Data 1 Systems