Comfort  Automation/ Security System Forums Home
Home Search search Menu menu Not logged in - Login | Register
Comfort Automation/ Security System Forums > Products > UCM > UCM Problems > Failed to connect to UCM/Ethernet

Failed to connect to UCM/Ethernet
 Moderated by: admin
 New Topic   Printer Friendly 
 Rate Topic 
AuthorPost
 Posted: Sunday May 1st, 2011 03:40 am
   
1st Post
rwm
Member
 

Joined: Thursday Nov 20th, 2008
Location:  
Posts: 8
Status: 
Offline

  back to top

I have updated Comfigurator from 3.1.9.0 to 3.2.8.0 and cannot get the PC to connect. I can ping the Comfort Ultra II, but not connect. Running on Windows 7 x86, connecting over ethernet. v3.1.9.0 ran correctly.

(I still have 3.1.9.0 installed on another PC Win7 x64, but am wary of updating it till the 3.2.8.0 works)



 Posted: Sunday May 1st, 2011 04:49 am
   
2nd Post
ident
Administrator


Joined: Wednesday Aug 9th, 2006
Location: Singapore
Posts: 3493
Status: 
Offline

  back to top

3.2.8 should not cause the UCM/Ethernet not  to connect as we are using 3.2.8 now with a UCM/Ethernet.
If you have 2 PCs on the network with 3.2.8 and 3.1.9 can you try to connect with both PCs to the same UCM/Ethernet?
However note that only 1 connection can be open at a time. If you connected using one PC you must disconnect before the other onecan connect. This may be the reason why you could not connect with the new Comfigurator, if  you had been connected with the other PC




 Posted: Sunday May 1st, 2011 01:48 pm
   
3rd Post
rwm
Member
 

Joined: Thursday Nov 20th, 2008
Location:  
Posts: 8
Status: 
Offline

  back to top

Thanks for the reply. What caused the problem was that on upgrade the Port was set to 1001; when I set it back to 10001 the connection worked. Have now updated both PCs to 3.2.8.0 - both can now independently connect.



 Current time is 08:54 am
Comfort Automation/ Security System Forums > Products > UCM > UCM Problems > Failed to connect to UCM/Ethernet
Top




UltraBB 1.172 Copyright © 2007-2014 Data 1 Systems