Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > Remote Controls > Pronto, Comfort 1 and Ethernet UCM |
Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > Remote Controls > Pronto, Comfort 1 and Ethernet UCM |
| Moderated by: admin | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
kevinsales Member
|
Hi Guys, Am i correct in assuming that this will ONLY work with the ethernet UCM, and not with the serial UCM and the philips pronto RFX9600 extender? Also i was told i can use the ethernet UCM with my version of comfort 1, but not able to use it for control with the ipod, would this also be the case with the Pronto 9600? "Correct, you have Comfort I Ultra 4.156 You should be able to use a UCM/Ethernet with this system But not if you are planning to use the Comfort iPhone app as you need Comfort II for that" - Cytech admin Thanks Kevin |
|||||||||
|
slychiu Administrator 
|
Comfort I should work with UCM/Ethrnet However I am not sure if Pronto module will work fully with Comfort I as it was developed with Comfort II. Some of the commands may depend on Comfort 2 We have not tested the RFX9600 extender. If it has the same commands then it may be able to work with UCM/232 |
|||||||||
|
kevinsales Member
|
Thanks, i shall have a play with the ucm232 see if i can work the protocols first. |
|||||||||
|
kevinsales Member
|
Hi does anyone had the RS232 protocals availible for the comfort system so i can try and work a RFX9600 - UCM/232 for my comfort? Thanks Kev. |
|||||||||
|
slychiu Administrator
|
Send an email to support@cytech.biz. We will send the protocol in return By the way our new Universal UCM supports RFXCom already but that needs Comfort 2 |
|||||||||