Comfort is on latest 6x UCM Network again on latest 6x ..
New board is going in the attic so though I would be smart(hah) and upgrade it first :-)
Sticker on it says current firmware is SEM 5.139
Thought easiest way of doing it would be just to plug a 485 cable into it which I thought would give me 12v ov and the data bus.
Green light appears and then flashes.
I fire up Configurator go to modules then scan for new slave. - Get an error message "Communication Error or Comfort or UCM Firmware does not support scan"
Think to myself maybe as its such old firmware - so then I try to upgrade it from the UCM using the programmign cable but keep getting upgrade error.
So now am a bit stuck - anyone tell me how to do it?
Thanks
StuartLast edited on Friday Oct 14th, 2011 04:33 pm by schford
|