Comfort Automation/ Security System Forums Home
Home Search search Menu menu Not logged in - Login | Register
Comfort Automation/ Security System Forums > Products > UCM > UCM Problems > ETH02 Connection Timeout setting

ETH02 Connection Timeout setting
 Moderated by: admin
 New Topic   Reply   Printer Friendly 
 Rate Topic 
AuthorPost
 Posted: Wednesday Oct 26th, 2011 10:44 am
   PM  Quote  Reply 
1st Post
gaynorc
Member
 

Joined: Sunday Dec 31st, 2006
Location: Ireland
Posts: 130
Status: 
Offline

  back to top

On the ETH02 I purchased this august, the "connection timeout (min)" entry in DS Manager was set to 5 minutes.

In the UCM manual downloaded from Cytech the diagram shows the "connection timeout (min)" set to "0=Disabled".

Which setting do you advise for use with ETH02?

Thanks


 Posted: Wednesday Oct 26th, 2011 10:57 am
   PM  Quote  Reply 
2nd Post
ident
Administrator


Joined: Wednesday Aug 9th, 2006
Location: Singapore
Posts: 3493
Status: 
Offline

  back to top

This should be set to 1 minute especially if used for iPhone
It disconnects if there is no communications for the idle time so it avoids a device hogging the connection
Only 1 connection at a time is allowed to the UCM/Ethernet
It is also good for security so that someone cannot pick up the phone or computer and control your system

The new firmware/application for the ETH02 should also be used


 Current time is 04:06 am
Comfort Automation/ Security System Forums > Products > UCM > UCM Problems > ETH02 Connection Timeout setting
 Top

UltraBB 1.172 Copyright © 2007-2014 Data 1 Systems