KNX Physical Address Limits - KNX (EIB) - Third Party (interfacing to Comfort) - Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > KNX (EIB) > KNX Physical Address Limits

KNX Physical Address Limits

Moderated by: admin

Author	Post

Posted: Saturday Feb 18th, 2012 12:45 pm

ident
Administrator

In the KNX Properties page, the physical address (also known as Individual Address) can be set to the following range of values;

KNX Area can be set to 0 to 15
KNX Line can be set to 0 to 15.
Physical Address can be set to 1 to 200. Values higher than 200 should not be entered as this will cause an error due to the firmware. Comfigurator 3.4.4 will prevent values > 200 from being entered

Last edited on Saturday Feb 18th, 2012 12:49 pm by ident

Current time is 05:25 pm

Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > KNX (EIB) > KNX Physical Address Limits