If you put maglock in parallel surely it wont work as you still have a closed circuit! the way you have described it the circuit should be in series so either one will open the circuit releasing the maglock.
However I use electronic door bolts which are connected directly to a relay and then they are controlled by two different methods.
1) through use of an app on mobile phone
2) I have connected an RF remote relay to a Zone/input when pressed registers zone activation and commands door lock to release
RF relay is third party and is stuck with double sided adhesive inside panel.
I have to admit the remote is far easier to use than going through phone all the time. A switch can be used directly on the same input as the circuit is configured as normaly open this can also be configured as normally closed but must also be wired in series with relay etc
Last edited on Monday Jul 14th, 2014 09:31 pm by Swiss-Toni
|