UCM/Zwave will update status bar on Comfigurator Zwave screen .
After Virtual Node operations UCM/Zwave will automaticallly read EEPROM when required and send to Comfigurator without having to Learn the network again from the primary controller
Zwave Action has a new Multilevel Dimming function
UCM/Zwave will update Comfort counters and sensors from Zwave commands even when the counter value has not changed. This allows status of Zwave devices controlled by Comfort and other Zwave nodes to be synchronised
The status messages show the status of the UCMs which were formerly available only by seeing the state of the LEds BUSY1, BUSY2, ERROR eg for Zwave
Normal/No error
EEPROM missing/faulty
EEPROM insufficent capacity
EEPROM data invalid
Communication error between UCM baseboard and Z-wave sub-module
I see on the downloads area a version 7.014 which is not indicated to be a Beta version. However I cannot find an entry in the forum for this 7.014 as the latest firmware, nor a description of its effects. Can you point me to the page please?
Thanks
Last edited on Sunday May 12th, 2013 06:04 pm by gaynorc
Please note that if you downloaded Zwave 7.014 from the server before today, it was the wrong version uploaded by mstake
Please use the Zwave 7.014 with todays date