Comfort Automation/ Security System Forums > Products > UCM > Ethernet UCM/ETH03 > Upgrading Firmware on ETH03 Submodule |
Moderated by: ident |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
ident Administrator
|
The ETH03 firmware is NOT the same as the UCM firmware of the baseboard. The ETH03 firmware runs on the ETH03 submodule module and not the UCM. The UCM Firmware is the firmware on the UCM Baseboard (marked by UCM 7.xxx label). UCM Firmware is upgraded by right clicking on the UCM in Modules and selecting "Check for Upgrades" see http://www.comfortforums.com/forum92/3400.html ETH03 Firmware runs on the ETH03 submodule, The 'Upgrade' button is used to upgrade the ETH03 firmware on the submodule over the network. Firmware upgrades are available from the Cytech Technology website at http://www.cytech.biz/eth03_firmware.html There are 3 zipped .hex files available ETH03-General.hex is for UCM/ETH03 ETH03-client.hex is for UCM/Universal ETH03-heatmiser is for UCM/Heatmiser (wifi) After downloading the zip file and unzipping, select the ETH03-General firmware (.hex file). It is advisable to check the website for the latest ETH03 firmware and upgrade the firmware before use. In Comfigurator, go to Options > Settings > UCM Connections Select UCM Interface= Network (Local) Click on the link for Comfort Server Manager (in blue) Note the ETH03 firmware version is in the window as highlighted (ETH03GE2.23) (The CS Manager Software is on the bottom (Version 2.1.0). To Upgrade CS Manager software see http://www.comfortforums.com/forum113/3821.html ) Click on the Upgrade Button to upgrade ETH03 firmware Browse to the folder containing the firmware hex file, eg ETH03General 1.12.hex Press OK to start the upgrade The progress of the upgrade is seen in the progress bar on the bottom right. The process may take less than a minute, and the status "Success" should be seen The IP address of the UCM/ETH03 will be blank after the upgrade. Press Refresh to detect the IP address and the new firmware should be shown Last edited on Sunday Feb 11th, 2018 09:42 am by |
|||||||||
slychiu Administrator
|
Please upgrade the UCM firmware to 7.060 or above before upgrading ETH03 firmware to 2.14 or above If ETH03 firmware is 2.14 and you are not able to connect to the UCM/ETH03, please downgrade ETH03 firmware to 2.01. This should allow you to connect to the UCM/ETH03. Upgrade UCM firmware to 7.060 (or above) then upgrade the ETH03 to 2.14 (or above) |
|||||||||
Julian.Driver Member
|
I have CSM 2.0.6 which will not connect upon refresh, and doesn't have a refresh button! I cn find Comfort on the network very easily with other tools. UCM07 is v 7.028, comfort v 7.057, configurator 3.9.7.0. Is ther a version mismatch here? Attachment: Capture.JPG (Downloaded 117 times) |
|||||||||
slychiu Administrator
|
See the possible causes of this here UCM/ETH03 cannot be seen in Comfort Server Manager http://www.comfortforums.com/forum113/3823.html |
|||||||||
slychiu Administrator
|
if ETH03 cannot be seen in CS Manager, you can upgrade the ETH03 firmware using the method described here http://www.comfortforums.com/view_topic.php?id=4426&forum_id=113 |