Comfort Automation/ Security System Forums Home
Home Search search Menu menu Not logged in - Login | Register
Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Outputs > How to connect GJD opal XL external PIR

How to connect GJD opal XL external PIR
 Moderated by: slychiu
 New Topic   Reply   Printer Friendly 
 Rating:  Rating
AuthorPost
 Posted: Wednesday Jan 7th, 2015 09:08 pm
   PM  Quote  Reply 
1st Post
ComfortGeek
Member


Joined: Thursday Jul 12th, 2012
Location:  
Posts: 66
Status: 
Offline

  back to top

Hi - I just cant seem to get the external PIR to work

I've connected power to the unit and the 'A' output from the PIR  to the zone, as it says in the manual and have programmed the zone as NO switch but cant get it to work

What am I doing wrong?  I've attached the manual for ease

Kind regards,

CG

Attachment: Opal-XL-Manual-.pdf (Downloaded 9 times)


 Posted: Saturday Jan 10th, 2015 02:01 pm
   PM  Quote  Reply 
2nd Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5742
Status: 
Online

  back to top

Are you sure that it does not work? Did you do a Security check F,3,2 and test the sensor?

How are the EOL setting for the zone? I suggest to set for NO EOL resistors and do not connect any EOL resistors

If it does not get detected, measure the voltage between the zone  and common when there is no motion and when there is motion

the voltage should be 1.2V if no motion and 0V if there is motion (approximately) with NO EOL resistors and shunts accordingly

Last edited on Saturday Jan 10th, 2015 02:08 pm by slychiu


 Posted: Saturday Jan 10th, 2015 03:05 pm
   PM  Quote  Reply 
3rd Post
ComfortGeek
Member


Joined: Thursday Jul 12th, 2012
Location:  
Posts: 66
Status: 
Offline

  back to top

Thanks.

Can you confirm the wiring is correct?

Gjd - comfort
-------------------
12v - 12v
0v - 0v
A - zone input
Nothing in zone common

Thanks as always


 Posted: Saturday Jan 10th, 2015 07:27 pm
   PM  Quote  Reply 
4th Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5742
Status: 
Online

  back to top

Yes. Correct


 Posted: Sunday Jan 11th, 2015 07:51 pm
   PM  Quote  Reply 
5th Post
ComfortGeek
Member


Joined: Thursday Jul 12th, 2012
Location:  
Posts: 66
Status: 
Offline

  back to top

Thanks.  Ok, I've now got 2 out of 3 working.  There must be a fault with the 3rd unit.

Thanks for helping me resolve this issue.

Kind regards

CG


 Current time is 08:25 am
Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Outputs > How to connect GJD opal XL external PIR
 Top

UltraBB 1.172 Copyright © 2007-2014 Data 1 Systems