I have 4 scs switches, but two of them are no longer used so I need to remove them from my configurataion. I go to modules and settings, delete the removed ones, and then do a selective upload to update modules and setting.
However, once I do this, and then do a scan for all modules, comfort still detects 4 scs switches, even though two are removed, so it should only detect the remaining two ?
Would appreciate some quick advice on this, heading away tomorrow, so just want to get the comms failure cleared.
When you removed the SCS from the configuration did you also remove them from the system physically and change the ID setting so that the remianing ones are ID 1 and 2? If the SCS remain connected then Comfigurator will detect them and add them again