Comfort Automation/ Security System Forums > Products > Scene Control Switches (OBSOLETE) > removing scs switches from comfort |
Moderated by: admin |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
wexfordman UCM Pi Users
|
Hi, I have 4 scs switches, but two of them are no longer used so I need to remove them from my configurataion. I go to modules and settings, delete the removed ones, and then do a selective upload to update modules and setting. However, once I do this, and then do a scan for all modules, comfort still detects 4 scs switches, even though two are removed, so it should only detect the remaining two ? Would appreciate some quick advice on this, heading away tomorrow, so just want to get the comms failure cleared. Regards,Eamon |
|||||||||
slychiu Administrator
|
When you removed the SCS from the configuration did you also remove them from the system physically and change the ID setting so that the remianing ones are ID 1 and 2? If the SCS remain connected then Comfigurator will detect them and add them again |
|||||||||
wexfordman UCM Pi Users
|
Hi, the scs are removed, but I didn't change the IDs of the remaining ones so that might be the problem |