KNX 7.087
Bugs- Date and Time from KNX (when mapped to KNX) did not get sent to Comfort
Bugs Fixed- Fixed Bug - bypass zone to KNX did not work
- Fixed bug on Bypass zones to KNX
- Fixed bugs in security modes to KNX.
- Fixed bugs in EIS10 2 byte counter, EIS5. sFixed bugs in EIS10 2 byte counter, EIS5.
- Fixed BUG: Action send command to KNX does not update Comfort register which is mapped to the KNX address
Changes- Even if counter> KNX 1 bit programmed, send to KNX > Comfort 1-byte group address if present. Even if counter> KNX 1 byte programmed, send to KNX > Comfort 1 bit group address if present
- When sensor value changes, send sensor value to mapped KNX address KNX to Comfort mapped to Comfort sensor.
- When security mode changes, send value to KNX to Comfort for security mode group address.
- Added Status Message "invalid physical address"
- UCM/KNX2 Status Error will appear if no confirmation for telegram to KNX.
- Improved status report to Comfigurator
- If no EEPROM, flash ERR LED
UCM/KNX1 firmware 7.079 can be upgraded to UCM/KNX2
Last edited on Sunday Jul 21st, 2019 03:49 am by slychiu
|