Comfort  Automation/ Security System Forums Home
Home Search search Menu menu Not logged in - Login | Register

Unable to connect to UCM eth02
 Moderated by: ident
 New Topic   Reply   Printer Friendly 
 Rate Topic 
AuthorPost
 Posted: Wednesday Apr 17th, 2019 08:47 am
   PM  Quote  Reply 
1st Post
waynebr
Member


Joined: Friday May 1st, 2009
Location: United Kingdom
Posts: 89
Status: 
Offline

  back to top

After several years of the system running well I decided to add some more functions and installed a ucm z-wave. I was able to connect to everything using configurator.
I then did the firmware upgrades and I thought all was fine. I went back to the system a couple of hours later and it appears that ucm eth02 is not connecting to the network. If I run the dsmanager on the network nothing Is found but if I plug the module directly to my laptop I can see the UCM and set the IP or dhcp.
When plugged into the lan the device does not show up in the list of connected devices on my router list.
Can anyone help me trouble shoot this?



 Posted: Wednesday Apr 17th, 2019 09:40 am
   PM  Quote  Reply 
2nd Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5493
Status: 
Offline

  back to top

Check if you have another network adaptor in the systemdisconnect all other network adaptors



 Posted: Wednesday Apr 17th, 2019 09:55 am
   PM  Quote  Reply 
3rd Post
waynebr
Member


Joined: Friday May 1st, 2009
Location: United Kingdom
Posts: 89
Status: 
Offline

  back to top

Hi do you mean disconnect everything else from the router? I don't have any other network adapters in comfort.

Also what firmware version should be installed, want to make sure I have the correct one.



 Posted: Wednesday Apr 17th, 2019 10:05 am
   PM  Quote  Reply 
4th Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5493
Status: 
Offline

  back to top

Not network adaptors in ComfortOther network adaptors on the computersee http://www.comfortforums.com/forum113/3823.html which is for ETH03 but also applies to ETH02
Anyway if it can work by directconnection to the PC use DS Manager to set the IP address of ETH02, then connect ETH02 to the network and enter the IP addtess and port
ETH02 is not produced anymore. I auggest that you get a ETH03 to replace the ETH-02 to avoid future problems



 Posted: Wednesday Apr 17th, 2019 02:50 pm
   PM  Quote  Reply 
5th Post
waynebr
Member


Joined: Friday May 1st, 2009
Location: United Kingdom
Posts: 89
Status: 
Offline

  back to top

Thanks I will try when I get back. I want to get thr pi module when available. Mot sure if this will negate the need for an eth03



 Posted: Wednesday Apr 17th, 2019 06:32 pm
   PM  Quote  Reply 
6th Post
waynebr
Member


Joined: Friday May 1st, 2009
Location: United Kingdom
Posts: 89
Status: 
Offline

  back to top

Thanks this worked and I can connect again



 Current time is 12:37 pm
Top




UltraBB 1.172 Copyright © 2007-2014 Data 1 Systems