Comfort Home Automation/ Security System Forums Home
Home Search search Menu menu Not logged in - Login | Register

Comfort Firmware 7.160
 Moderated by: ident
 New Topic   Reply   Printer Friendly 
 Rate Topic 
AuthorPost
 Posted: Sunday Jul 28th, 2019 07:49 am
   PM  Quote  Reply 
1st Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 4669
Status: 
Offline

  back to top

Comfort Firmware 7.160
Known Bugs (old bugs)
  • Force arm on partition using # key does not work always send to partition 0
  • Partitions do not work well with UCM log in/ETH03
Bugs Fixed
  • Fixed BUG For Partition Systems trouble alarms are registered into random partition and Restore may be registered to different partition so cannot acknowledge
Actions (Comfigurator 3.12.13)
  • Action 160 - switch S12V off time if time = 0, dont start timer for on time
  • Action 159, 0, 3 Convert  256 to 100 use fractional value and round off
  • Actions subtract parameters for Action 149, 3  (immediate), 149, 4 (counter), 149, 5 (sensor)
Event Log
  • Eventlog - command E?FF last event Fixed BUG did not work
  • For EMS sensor event log, if module which reported sensor has Communications Failure, set sensor value to 255 so KP04A display does not remain unchannged as last value reported, and causes alarm
Partitions
  • If there is no partition 0, trouble alarms report in lowest partition
  • For partition system turn off all keypad speakers first so only partition keypad can hear siren sound  and announcement
  • Fixed BUG For Partition Systems trouble alarms are registered into random partition and Restore may be registered to different partition so cannot acknowledge
Keypad
  • KP06A Keypad volume has max 100. KP06A volume is actually divided by 2
GSM
  • If an SMS dialout fails,  immediately go to the next dial without time out delay
Counters
  • The Counter Response is also activated when Comfort changes a Counter value. Eg by Responses/ Action codes or Control menu. Previously, Counter Response is avtivated only when the counter us changed by a UCM
CM9001-EMS Environmental Monitoring System
  • Support Fractional Values for KP04A display
  • For EMS sensor event log, if module which reported sensor has Communications Failure, set sensor value to 255 so KP04A display does not remain unchannged as last value reported, and causes alarm
  • Implemented Sensor calibration with Fractional value 1/16 for EMS
  • Sensors adjustment for scale fix bug for division
  • For EMS sensor event log, fixed BUG that sensors 9 onwards are not recorded correctly. Changed so that any sensor with counter assigned is recorded in event log every hour
  • Sensor Register calibration in eepron is 1/16 units to use calibration value with 1/16 unit calibration value from eeprom
Comfort Protocol
  • ETH03 plug in support UN command
  • s? s! Comands retiurn 3rd byte
  • For plug in eth03 for LGX, UCM/LOG, CM9001,   Sensor, Counter, Flag command will echo state eg C! Will  report CT
UCM/Logic, KNX/Logic
  •  No of Responses number from 1024 to 512 affect ucm/log, knx/logic
  •  Removed  x10 responses not used affect knx/logic and ucm/logic
  •  KNX/Logic saved nonvolatile counters increased from 8 to 32


Last edited on Sunday Jul 28th, 2019 07:50 am by slychiu



 Current time is 05:58 am
Top




UltraBB 1.172 Copyright © 2007-2014 Data 1 Systems