Comfort  Automation/ Security System Forums Home
Home Search search Menu menu Not logged in - Login | Register

New system after upgrades has all Flags set to ON
 Moderated by: ident
 New Topic   Reply   Printer Friendly 
 Rate Topic 
AuthorPost
 Posted: Wednesday May 6th, 2020 10:16 pm
   PM  Quote  Reply 
1st Post
CTx
Member
 

Joined: Thursday Apr 9th, 2020
Location: Portugal
Posts: 17
Status: 
Offline

  back to top

This was a surprise as I cannot understand any good or bad reason for it.
Being so apparently unreasonable, I question myself if it could be something caused by me.But what? I do not even know how to do it so thoroughly (ALL Flags)
I noticed because I had setup a response 75 to zone 1 as it is always nice to have an audible response to testing.
It was chiming before firmware upgrades performed on all modules (see previous topic).Right after FW upgrades I heard no more chime and thought it was something with the sensor on zone 1. Played response 75 directly from Configurator and no chime.I assigned zone announce to zone 1 and it was working fine.I played DoorPhoneChime (response 67) and chime was played
Response 75 tests Flag1=0 to play the sound (although it says it tests Flag16 - old error)I checked the flags and they were all set to ON.Cleared Flag1 and chime was again OK with response 75
Then I looked if I could Write Selectively Flag1 to 0 from Configurator to Comfort (just to check)I found I could not (no selection) Therefore I could not have done ALL Flags ON this way.
So, my questions are:
  1. Is it supposed to start with all Flags ON as default (previously all flags OFF) ?
  2. If yes, why ? and how it helps ?
  3. If not, how can that possibly have happened to me ? How can that be done, even if unintentionally
  4. How can I "undo" ALL Flags ON and set them OFF?
ThksCarlos



 Posted: Thursday May 7th, 2020 04:37 am
   PM  Quote  Reply 
2nd Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5493
Status: 
Offline

  back to top

Yes in this firmware if the system is new, all flags are turned on by default. The next firmware will fix this
For now I suggest that you go to the Comfort Registers screen and turn off the flags that you are using by checking the box for the flags

see    http://www.comfortforums.com/forum126/4677.html for Comfort Registers window


Last edited on Thursday May 7th, 2020 04:37 am by slychiu



 Current time is 09:15 am
Top




UltraBB 1.172 Copyright © 2007-2014 Data 1 Systems