| Posted: Friday Feb 25th, 2022 05:35 pm |
|
1st Post |
Ian
Member
| Joined: | Saturday Aug 19th, 2006 |
| Location: | United Kingdom |
| Posts: | 241 |
| Status: |
Offline
|
back to top
|
I have added a couple of z-wave window sensors to my z-wave network. I want to add them to comfort as part of the alarm system.I did the usual 'learn' procedure and after a couple of attempts it started to learn. Then Comfigurator stopped learning and the primary controller showed an error message.I tried again but nothing is happenning.Now I see an error in red in the bottom left of the Comfiguratot window; Communication error between UCM baseboard and Z-wave sub-module.I have restarted both Comfort and the primary controller (HomeSeer)
Any suggestions of what may be wrong?Comfort 2 UltraZ-wave module
|
| Posted: Friday Feb 25th, 2022 05:52 pm |
|
2nd Post |
Ian
Member
| Joined: | Saturday Aug 19th, 2006 |
| Location: | United Kingdom |
| Posts: | 241 |
| Status: |
Offline
|
back to top
|
OK - I powered down then up the UCM and it now seems to be talking to the z-wave again!
|
| Posted: Saturday Feb 26th, 2022 02:53 am |
|
3rd Post |
slychiu
Administrator
| Joined: | Saturday Apr 29th, 2006 |
| Location: | Singapore |
| Posts: | 5431 |
| Status: |
Offline
|
back to top
|
Zwave is a bit flaky sometimes. I am glad you got it working
|
|
