Comfort Automation/ Security System Forums > Support > Questions on Programming Comfort > Comfigurator losing EOL setting |
Comfort Automation/ Security System Forums > Support > Questions on Programming Comfort > Comfigurator losing EOL setting |
| Moderated by: slychiu | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Majik UCM Pi Users
|
Using Comfigurator v 3.13.7.0 to program a recently upgraded system with a CM9001 board, which has the EOL settings programmed, rather than as hardware shunts. I find that, quite often, Comfigurator loses the Double EOL setting and reverts all zones back to "No EOL", which is a problem if I don't notice it's done this, and upload the configuration, only for the system to erupt with Tamper alerts. I've not yet worked out what sequence of usage causes this. Cheers, Keith |
|||||||||
|
slychiu Administrator 
|
I have not encountered this. It may be doe to scanning for modules not getting the correct info. Defaulti s Shunts. Watch out for this after log in as there is an automatic scan for modules |
|||||||||
|
Home Comfort Installers
|
Yes have experienced this on many occasions I expect that pressing the update defaults button will fix it ! |
|||||||||