I can arm/ disarm with WizComfort/Keypad and voice on external power speaker is OK (via Line Out 3mm jack). Just there is no sound on built-in PC/ Speaker & Mic (via Out+GND UCX PCB' terminal to Mic input of PC);
UCX 5.92 (with Audio); Comfort firmware 5.45; WizComfort version 1.4.6.
What shall I need to check?
Thanks
Even I can see the command from Comfort to PC as SM000040, SM000140, SM000000 after the command ... as below within Comfort monitor
I?0101
PS00
SM000040
SM000140
MD025A
AM095A
KL01000000
AL130000BF025A
KL01000000
SM000000
Last edited on Monday May 14th, 2007 03:16 am by namnp
|