We are now 4 months later since your last message (estimating the production to about 3 months if no delay). Is it possible to have an ...   Monday Sep 5th, 2011 11:34 am

Hello, Thanks for investigating in this. It's good to know that I'm not crazy and my problem is real :) I hope you'll be able to find a ...   Thursday May 26th, 2011 03:20 pm

I just sent an email to cytech support including my basic cclx file. Thanks for your help. ...   Tuesday May 24th, 2011 05:03 pm

Well, I'm not receiving any messages on the "bypass" group addresses on the bus then. Either ETS group monitor is missing them (but I don't see ...   Thursday May 5th, 2011 06:37 am

Hello again, I just ran some test with ETS and it seems that writing 1bit to the group address for zone 1 bypass is working fine. ...   Wednesday May 4th, 2011 05:21 pm

Thanks for the fast reply. I'll try writing a 1bit value then. I'm almost sure I already tried before. So you mean that if my "Bypass Zone ...   Wednesday May 4th, 2011 09:56 am

Hello again, I need some help regarding zone bypassing using KNX. I assigned group addresses to the "zone bypass" KNX to Comfort values. The UCM/KNX manual states that ...   Wednesday May 4th, 2011 08:36 am

Indeed, that would be laborious. We agree :) Resetting the UCM KNx or being able to read the values is definitely a lot better, but not ...   Wednesday Apr 20th, 2011 01:20 pm

What a fast answer ! :) Thanks for the clarification about sending the counter state to KNX. So the loopback "Comfort to KNX" -> "KNX to Comfort" ...   Wednesday Apr 20th, 2011 12:50 pm

I was thinking again about this "re-trigger KNX events" feature... Without any new development, wouldn't it be possible to assign the UCM/KNX events (Comfort to KNX) ...   Wednesday Apr 20th, 2011 11:55 am

Well, that could be another feature to implement in the next firmware release :) ...   Tuesday Apr 19th, 2011 02:05 pm

Thanks again for the prompt answer ! I'm glad I was right with the possibility to use the RIO for such a use. I understand that I ...   Tuesday Apr 19th, 2011 01:30 pm

Hello again, I have another question, this time regarding RIO and the PIR power supply. In one room (i.e. bedroom), I would like the PIR to be ...   Tuesday Apr 19th, 2011 12:57 pm

Thanks for your fast answer ! Reading values directly from comfort would indeed be -in my opinion- a nice feature to have. I'm looking forward to ...   Tuesday Apr 19th, 2011 11:00 am

Hello cytech community. First of all, sorry if this question is too basic. I'm quite new to comfort and KNX so please forgive me. I'm trying to ...   Tuesday Apr 19th, 2011 07:22 am