Comfort Automation/ Security System Forums

Having never installed a Comfort System before, would it be OK for you guys to just go over my shopping list, just incase there is any drastic errors in the design.

Brief background:

• Have 3 storey house
  
• Centralizing system on each floor with Slave unit
  
• Including Fire detectors.
  
• Utilzing basic lighting control with Comfort modules

Shopping List

• 1x CP9000-ULT/EN03
  
• 2x SEP01/M2/EN03
  
• 3x LEM02-M2 (To connect to SEP and main CPU)
  
• 1x UCM05
  
• 1x TPB01
  
• 1x RGR04
  
• 3x TWS02 *
  
• 3x Batteries
  
• 3x KP03E (For each floor)
  
• 1x DP03
  
• 1x DP03_Hood
  
• 7x PIRs
  
• 4x Mag Contacts
  
• 2x ROR Fire Sensor (12v)
  
• 10x Optical/Heat Sensors (12v)
  
• 3x 16R - 8 Pack (2k7 & 4k7) Zone Resistors
  
• CAT5e UTP or STP Cable (depending on audio tests)
  
• 6core Alarm Cable
  
• 3x Internal Sounders (for each floor)

* I will be installing one TWS02 into each SEP and main CPU enclosures to control 2 lights on each floor. I have already rewired the house and centralized the lighting cables to a single location (eg cables to each light switch and light bulb).


For the boards I am installing with the main and slaves, will there be enough room in the provided enclosures?


Thanks for your help


Adam.

Your equipment list should be sufficient for the configuration
The TWS modules is normally mounted in a separate enclosure from the low voltage Comfort modules so that there is sufficient separation. Other than that the space should be sufficient.

Thanks for the info.