Comfort Automation/ Security System Forums

The z-wave UCM has the firmware flash pins - but no serial connection. Given what Cytech normally do with UCM\'s, you\'d think the flash pins wouldnt be there if not possible.

I would also have to remove the daughterboard, and place a ethernet module there so it could act as the source to flash a UCM05 ?

Or is the flash pins there so the zwave can be flashed by a UCM05, but not the other way around ?

Possible ?

The Zwave programming pins are there to be flashed by  UCM05, it is not able to do the flashing even if you plug in the Ethernet module as the communications firmware on the serial interface side is different from the UCM05 or ethernet, it talks to Zwave instead