Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > Zwave > Sending on/off commands in Comfigurator beta
Full Version: Sending on/off commands in Comfigurator beta
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

palmlodge

11-30-2008, 06:12 PM
How do we just send an on/off command ?

I see a dimming preset in there, but no on/off

Assuming we need to select \"device command\" and then the ID, whats the DataList to turn a device on or off ?

admin

12-01-2008, 04:03 AM
On and off are all incorporated into the \"Dim Level\" commands, that is the Zwave protocol
To send an OFF command, set Dim level 0
To send an ON command, set Dim level 255
Dim levels 1 to 99 are percentages which only apply if the device is dimmable

palmlodge

12-01-2008, 06:24 AM
thnx
Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > Zwave > Sending on/off commands in Comfigurator beta