Comfort Automation/ Security System Forums

Comfort Automation/ Security System Forums > Products > Questions on Using Comfort > Ouput Numbering
Full Version: Ouput Numbering
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Warby

12-02-2008, 02:08 PM
I have a system with 2 slaves. I cannot seem to get OP1 to activate on the third (2nd Slave) Board to work. is this op33 even if we are using LEMs without OP\'s?
It is just turning on a sounder which is working on the other boards and if i connect the output to 0v it works so all cabiling is correct.
TIA

slychiu

12-02-2008, 02:26 PM
Warby
This could be related to a known problem which is fixed by a Slave firmware (unreleased as yet)
I will send you the firmware file by email as we would like to see if this fixes your problem


Comfort Automation/ Security System Forums > Products > Questions on Using Comfort > Ouput Numbering