Comfort Automation/ Security System Forums

how can i connect the GND of IRR01 to The RIO PCB?

THANKS

Quote:IRR01 has no ground connection, the two wires are 12V and IR These connect any input on a RIO 12V to 12V centre common and IR to an Input

Correction
IRR has 12V, GND and IR pins
12V is connected to 12V on RIO
GND is connected to Input COM (Common) on any RIO Input terninal block (shared by 2 inputs)
IR is connected  to any Input of the RIO

But IRRo1 have 3rd wire GND , i read this in RIO module & IR dome .

this what i read in the Module
(IRR01) to receive Comfort Infrared Codes or X10 IR codes (from theX10 IR/RF handheld remote control UR24). The IRR01 IR receiver isconnected by 3 wires to the RIO; 12V, Ground, and IR. The IRR01 can[font=\"Verdana\"][size=\"1\"] be located up to 100 meters from the RIO.[/size][/font]

Sorry you are correct. See my amended reply above

thank u.