Right, I.ve been trying to use counters for my page and it does not seem to be working. Again, I think it is not working because my cwm02 firmware will not display up to date counter information ?
Could anyone confirm this ?
Counters monitoring are a basic feature of the CWM so it wil not be a firmware issue
Can you send your cclx file and CWM files to support@cytech.biz so we can check what the problem is
Hi,
I tried to send files, but got failed response, mailbox full ?
Here is what I am trying to do!
1) I am trying to get cwp to display x10 status by use of a counter.
2) I have a response (response 237) which turns on the lights, and sets counter value to 2
3) I have a similar response (response 209) which turns the ligts off again, and sets the counter value to 1
I have counter in cwm (cntr1), which both displays the status of the counter, with an on or off image depending on value of the counter.
I am probably missing somehting basic here, so apologies in advance.
Following on, here are the comfigurator files!
There was no mailbox full, we are investtigating the files
Hi Eamon,
You are missing out on the image files used for your CWM project (glenegare3.chd), can you send them to support@cytech.biz so we can better re-enact your settings here?
Hi Eamon
Have you sorted out that problem? We have not got your image files so we can run the simulation
Hi ident, sorry no! Havnt got round to it yet been mad busy!! Will post them up tonight if that\'s ok!