Comfort Automation/ Security System Forums

Hi friends,
 
I just finished installing MinderPro(comfort) at a residence. I have not given any keypad. Instead, I use 2 NO switches for the control purpose.
The first switch arms system(uses \'Autoarm Security Night\' function). Second switch disarms system along with putting siren off(\'Autoarm Security Off\', \'Siren Off\').
 
Whenever I program the board or restart it manually, It goes into night mode by pressing 1st switch. Works well.. Gives alarm on zone detection. When I press 2nd switch, siren becomes off and security becomes off.
Now when I press 1st switch to arm security again it fails to do so. I don\'t have keypad so god only knows what error might be occuring...
 
 
Please suggest..
 
I am attaching program for your reference.
 
Regards,
Manas

Not having a keypad is definately not a good idea. You are correct that only God knows what is happening
You can try to find out what happened by checking the Event log. Do TRansfer > Event Log

I found a link while searching.

http://www.comfortforums.com/forum36/1143.html

The problem resembles to the one at my site. Only difference is that I don\'t have kp.

I will try to upload the Event Log and post reply as early as possible.