Comfort Automation/ Security System Forums

Hi

I am starting my DIY install of Comfort, and have a question regarding connection of power to the main board.

The two wires (both brown) from the mains transformer have a blue connector on the end.

The main board power connection point also has an identical blue connector mounted on the board.

Am I supposed to remove the blue connector from the wires, and connect the wires to the board ?
If so - how do I know which way round to connect them ?

Cheers
Lee

Ahh, I am an idiot.

I just realised the connectors on the board pull off, and the transformer lead pops on in it\'s place.

Yes you remove (Unplug)  the terminal block on the board and connect the one from the transformer.
Polarity is not important as that is an Ac signal.